ECLIPSE:SECONDS
Method

How we compute seconds of totality

Published · Updated

Every figure on Eclipse Seconds comes from one engine, the same one that runs when you tap the totality map. This page explains where the numbers come from, how we check them and where they stop being exact.

How we calculate

Every time and duration on this site is computed from the polynomial Besselian elements published by NASA's Goddard Space Flight Center (Fred Espenak, VSOP87/ELP2000-82 ephemerides). For a given latitude and longitude we convert to geocentric coordinates, project the observer onto the fundamental plane and solve numerically for the four contact times: the start and end of the partial phase and the start and end of totality. We use ΔT = 69.2 s, an IERS-based estimate for August 2027, to convert dynamical time to Universal Time (UTC). The calculation runs in your browser, so any point on the map gets the same treatment as our town pages.

The four contacts, C1 to C4

  1. C1First contactThe Moon touches the Sun. The partial eclipse begins: glasses on.
  2. ·Partial phaseOver an hour of a growing bite.
  3. C2Second contactBaily's beads, then the diamond ring, then totality: glasses stay on until complete totality is confirmed.
  4. C3Third contactThe diamond ring and Baily's beads again, on the other edge: glasses back on before the first bright sunlight.
  5. ·Partial phaseThe bite shrinks again.
  6. C4Fourth contactThe Moon leaves the Sun. The eclipse is over.
C1, C2, C3 and C4 are the standard astronomers' names for the four "contacts" of an eclipse, used by NASA and every eclipse catalogue. Baily's beads and the diamond ring appear at both C2 and C3, on opposite edges of the Sun, and are direct sunlight. Take eclipse glasses off only once complete totality is confirmed, and put them back on before C3.

How we validate

Before a page goes live, its figures are checked against NASA's published values and independent calculators. Our engine reproduces NASA's greatest-eclipse duration for 2 August 2027 (6m 23s) to within a second. Near the edge of a path, where published predictions disagree by more than 2 seconds because of the uncertainty in ΔT (Earth's rotation), we show a range instead of one figure. Across eight test towns from Cádiz to Jeddah, durations agree with Xavier Jubier's smooth-limb calculator and a JPL DE440 calculation to within about 1–2 seconds, and contact times to within 1–2 seconds.

Does the Moon's shadow always move at the same speed?

No. The Moon's umbral shadow does not sweep the ground at a fixed speed. It is slowest near the subsolar point at greatest eclipse, roughly 1,700 km/h on some eclipses, and about 2,402 km/h (1,493 mph) for 2 August 2027 near Luxor, and much faster near the ends of the path, where the shadow cone meets Earth at a shallow angle (often many thousands of km/h).

We compute the speed from the NASA Besselian elements by tracking the shadow-axis intersection with Earth around local mid-eclipse. For the 2027 eclipse that gives about 2,402 km/h (1,492 mph) at Luxor and about 4,580 km/h (2,846 mph) at Tarifa. The same figure appears in every eclipse data block, town page and map result.

Known limits

Sources

Spotted a figure that looks wrong? Send a correction. More about who we are is on the About page.

Frequently asked questions

Does the Moon's shadow always move at the same speed?

No. The umbral shadow's ground speed varies along the path. Near the subsolar point at greatest eclipse it is slowest (about 2,402 km/h (1,493 mph) for 2 August 2027). Near the path ends, where the shadow strikes Earth at a grazing angle, it can reach many thousands of km/h. At Luxor it is about 2,402 km/h (1,492 mph); at Tarifa about 4,580 km/h (2,846 mph).

What are Besselian elements?

A compact set of numbers NASA publishes for each eclipse that describe the Moon's shadow over time. From them you can compute the exact times and duration at any point on Earth, which is what our calculator does.

What is Delta T and why does it matter?

Delta T is the difference between Earth's slightly irregular rotation and uniform atomic time. It shifts where on Earth the shadow falls by a few kilometres, so we use NASA's value for each eclipse.

Why might your time differ from another site?

Sites differ in Delta T, in whether they model the Moon's rough edge, and in elevation. Differences of 1 to 2 seconds are normal; larger ones usually mean a different spot.

What are the umbra and penumbra?

The umbra is the Moon's dark inner shadow: stand inside it and you see a total eclipse. The penumbra is the much wider outer shadow, where you only see a partial eclipse.